• Máy đo điện trở cách điện (mega-ohm) Fluke1587/ET

  • Đăng ngày 01-08-2016 10:03:11 PM - 2471 Lượt xem
  • Giá bán: Liên hệ

  • Establishing preventative maintenance programs are becoming critical to maintaining the uptime of electrical equipment and can significantly reduce both planned and unplanned downtime. Unplanned downtime costs are difficult to calculate, but often significant.


Số lượng

Fluke 1587 Insulation Multimeter

  • With the Fluke 1587, perform insulation tests, plus a wide-range of DMM tasks with confidence and ease.
  • Two products in one: Powerful and full-featured multimeter.
  • Ideal for work on motors, cables, and switch gear.
  • Large display with backlight.
  • Filter for motor drive measurements.
  • Insulation test (0.01MΩ to 2GΩ).
  • Insulation test voltages (50 V, 100 V, 250 V, 500 V, 1000 V) for many applications.
  • CAT III 1000 V /CAT IV 600 V overvoltage rating for added user protection.

Fluke i400 Current Clamp

  • Use the Fluke i400 with your Fluke 1587 to accurately measure AC current without breaking the circuit.
  • Use with your Fluke 1587 to measure 1A AC to 400 A AC.
  • 1 mA/Amp output guarantees easy reading.
  • CAT III 1000 V / CAT IV 600 V overvoltage rating for added user protection.
  • Specially designed to offer maximum utility in a very compact shape.
  • Maximum conductor: Ø 32 mm.

Fluke 62 MAX+ IR Thermometer

  • Dust and water-resistant: IP54 rated.
  • Rugged: 3-meter (9.8-foot) drop tested.
  • Ergonomically designed: Completely redesigned for a more natural hand fit.
  • Distance to spot: 12:1.
  • Dual lasers: Identifies area to be measured.
  • Large, backlit display: Makes data easier to read, even in dark areas.

Fluke 1587 Insulation Multimeters

 
Specifications
Voltage DC Maximum Voltage 1000 V
Accuracy ±(0.09%+2)
Maximum Resolution 0.001V
Voltage AC Maximum Voltage 1000 V
Accuracy ±(2%+3)
AC Bandwidth 5kHz*
*with low pass filter; 3db @ 800 Hz
Maximum Resolution 0.1 mV
Current DC Maximum Amps 400mA
Amps Accuracy ±(0.2%+2)
Maximum Resolution 0.01 mA
Current AC Maximum Amps 400mA
Amps Accuracy ±(1.5%+2)*
* 1kHz bandwidth
Maximum Resolution 0.01 mA
Resistance Maximum Resistance 50 MΩ
Accuracy ±(0.9%+2)
Maximum Resolution 0.1Ω
Capacitance Maximum Capacitance 9,999 µF
Accuracy ±(1.2%+2)
Maximum Resolution 1 nF
Frequency Maximum Frequency 100 kHz
Accuracy ±(0.1%+1)
Maximum Resolution 0.01 Hz
Temperature Measurement -40.0 °C to 537 °C
-40.0 °F to 998 °F
excluding probe
Diode Test Range 6 V
Resolution 1 mV
Accuracy ±(2 % + 1)
 
Insulation Test
Minimum Test Current @ 1kΩ/V 1mA
Test Voltages 50, 100, 250, 500, 1000 V
Maximum Resistance per Test Voltage 50V  
100V  
250V  
500V  
1000V 2 GΩ
Maximum Resolution per Test Voltage 50V 0.01 MΩ
100V 0.01 MΩ
250V 0.1 MΩ
500V 0.1 MΩ
1000V 0.1 MΩ
Accuracy per Test Voltage 50V ±(3 % + 5)
100V ±(3 % + 5)
250V ±(1.5 % + 5)
500V ±(1.5 % + 5)
1000V ±(1.5 % + 5) to 600 MΩ, ±(10 % + 3) above 600 MΩ
 
Environmental Specifications
Operating temperature –20 °C to +55 °C
Storage temperature -40°C to +60°C
Humidity (Without Condensation) 0% - 95% (10 °C – 30 °C)
0% - 75% (30 °C – 40 °C)
0% - 40% (40 °C – 55 °C)
Operating Altitude 2000 m
 
Safety Specifications
Overvoltage category Complies with ANSI/ISA 82.02.01 (61010-1) 2004, CAN/CSA-C22.2 NO. 61010-1-04, and IEC/EN 61010-1 2nd Edition for measurement CAT III 1000 V and CAT IV 600 V
Agency Approvals 2000 m CAT III 1000 V, CAT IV 600 V; 3000 m CAT II 1000 V, CAT III 600 V
 
Mechanical & General Specifications
Size 203 x 100 x 50 mm (with holster)
Weight 624 g
Warranty 3 years
Battery life Alkaline Meter use 1000 hours
Insulation test use Meter can perform at least 1000 insulation tests with fresh alkaline batteries at room temperature. These are standard tests of 1000 V into 1 MΩ with a duty cycle of 5 seconds on and 25 seconds off.
IP Rating IP40
 

i400 AC Current Clamp

 
Specifications
Nominal current range 400A
Continuous current range 1 A - 400 A
Maximum Non-Destructive Current 1000 A
Lowest measurable current 1 A
Basic accuracy 2% + 0.06 A 
(45-400 Hz)
(% reading + floorspec)  
Useable frequency 5 Hz - 20 kHz
Output level(s) 1 mA/A
 
Safety Specifications
Safety CAT IV 600 V, CAT III, 1000 V
Maximum voltage 1000 V AC rms from earth to ground, in compliance with EN61010
 
Mechanical & General Specifications
Warranty 1 year
Maximum conductor diameter 32 mm (1.25 inches)
Maximum conductor size (busbar) 750 MCM
Output cable length 1.5 m (59 inches)
Shrouded banana plugs Yes
 

Fluke 62 MAX+ Infrared Thermometer

 
Specifications

Temperature Range

-30 °C to 650 °C (-22 °F to 1202 °F)
Accuracy ±1.0 °C or ±1.0% of reading, whichever is greater
-10 °C to 0 °C: ±2.0
-30 °C to -10 °C: ±3.0
Response Time (95%) Fluke 62 MAX+ <300 ms (95% of reading)
Spectral Response 8 to 14 microns
Emissivity 0.10 to 1.00

Optical Resolution

12:1 (calculated at 90% energy)
Display Resolution 0.1 °C (0.2 °F)
Repeatability of Readings ±0.5% of reading or <±0.5 °C (1 °F), whichever is greater
Power AA battery
Battery Life 8 hours with laser and backlight on
Physical Specifications Weight 255 g (8.99 oz)
Size (175 x 85 x 75) mm (6.88 x 3.34 x 2.95) inches
Operating Temperature 0 °C to 50 °C (32 °F to 122 °F)
Storage Temperature -20 °C to 60 °C (-4 °F to 140 °F), (without battery)
Operating Humidity 10 % to 90 % RH non-condensing at 30 °C (86 °F)
Operating Altitude 2000 meters above mean sea level
Storage Altitude 12,000 meters above mean sea level
IP Rating IP 54 per IEC 60529
Drop Test 3 meters
Vibration and Shock IEC 68-2-6 2.5 g, 10 to 200 Hz, IEC 68-2-27, 50 g, 11 ms
EMC EN 61326-1:2006 EN 61326-2:2006

Standards and Agency Approval

Compliance EN/IEC 61010-1: 2001
Laser Safety FDA and EN 60825-1 Class II

 

Danh mục sản phẩm

Facebook
Thống kê
  • Đang truy cập64
  • Máy chủ tìm kiếm3
  • Khách viếng thăm61
  • Hôm nay2,832
  • Tháng hiện tại54,311
  • Tổng lượt truy cập2,444,194
Bạn đã không sử dụng Site, Bấm vào đây để duy trì trạng thái đăng nhập. Thời gian chờ: 60 giây